Dako Hybridizer User Manual Page 26

  • Download
  • Add to my manuals
  • Print
  • Page
    / 32
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 25
26 Dako Hybridizer | Handbook
Recommended for Best Results
Place glass coverslip over probe and sample
Apply sealant along all coverslip edges
Use Dako Humidity Control Strips S 2452
Slide Location
Hybridizer accommodates up to 12 slides per run. When prompted, lift lid and load slides onto plate using
slide locator for easy positioning. Frosted and/or label end of slides should be away from slide locator.
Move slides across plate until they rest against slide locator.
Note: If slides are not resting against slide locator, closing of lid may break slides.
Humidity Control Strips
Humidity Control Strips are used to minimize evaporation of assay solution. Located in the lid these strips
act to prevent evaporation of probe solution from prepared slides.
Instructions for use: After locating the slides, saturate strips with distilled water or deionized water
(approx. 13 mL for unused strips).
Instructions for reuse: After the run has ended, keep lid closed between runs to avoid drying out of the
strips. Do not reuse strips that have been dried out after initial saturation. Resaturate the strips before
starting a new run. The amount of water needed to resaturate the strip depends on the ISH procedure
and the time in between runs. Strips should be replaced frequently as they will degrade over time and
with use. See package insert for Hybridizer Humidity Control Strips for further instructions. Replacement
strips can be purchased for use with the Hybridizer.
If the Dako Hybridizer instrument has to stand unused for more than four days, open the lid, remove strips
and allow instrument to dry. It is recommended to allow the instrument to dry as described above with
each strip change and that the users keep the inner surface of the instrument in a clean condition. For
cleaning instructions advance to the cleaning section of this handbook.
To replace strips, lift lid and remove strips. Insert strips into slot positions; allow fingers in lid to support
strips.
Note: Do not use paper towels in strip positions, they must be folded and damage may result in lid
fingers.
Page view 25
1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32

Comments to this Manuals

No comments