Dako Hybridizer User Manual download pdf (Page 8)

8 Dako Hybridizer | Handbook

Section 1 | Unpacking and Installation

Inspect Packaging

The Hybridizer and its accessories are delivered in one carton. If the instrument or accessories have

suffered any damage in transport, please inform your carrier immediately.

Note: Save shipping carton and components to simplify return should service be required.

Verify Contents

The package contains:

One Hybridizer, code No. S 2450 (120V) or S 2451 (240V)

One Line Cord

One Handbook 30195

One CD (Handbook and Humidity Control Strips package insert) 30196

One Package Humidity Control Strips, code No. S 2452

Installation of the Hybridizer

1. Place the Hybridizer on a level surface suitable for laboratory instrumentation.

2. Hybridizer has an intake fan located on bottom and fan outlet in rear; assure no obstructions exist on

intake or outlet.

3. Position the Hybridizer away from direct sunlight and sources of heat or cold.

4. Verify voltage requirements located on serial number label, rear of instrument.

Connect Power

Plug the instrument into the appropriate outlet supplying the voltage and frequency indicated on the serial

number label. Main power switch is located on the rear of the instrument, next to the line cord power

entry module.

WARNING - North American Installation. Line cord should be plugged into a

properly grounded AC outlet.

WARNING - Outside of North America. Inspect that the supplied Line Cord got

local electrical compatibility.

EU Installation - Use power cord with an IEC320/CEE22 female connector and

male connector suitable for the power outlet to be used. Cord must meet

standards.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

No comments

Dako Hybridizer User Manual Page 8